Camouflet Convector Titanium

Convector Kit Includes:

• 1x Titanium Convector Device;
• 1x Titanium Camo Cap
• 1x Titanium Chamber with O-rings 
• 1x Stainless Steel Chamber Screen - Friction fit and replaceable
• 1x Titanium Stem
• 1x Single Bore Ceramic Tube
• 1x Camouflet Bamboo Box
  

How to use:

Loosely place your material of choice into the Convector chamber (do not pack the chamber too tight, the Convector needs airflow to extract properly), attach the Convector cap onto the chamber. Heat the tip of the cap for your desired length and then inhale from the stem opening. 

The Convector can be heated with any heat source, for optimal performance we recommend using the Convector paired with the Inductor, Camouflet's Induction Heater.

• Camo Cap - Precision heater plate assembly. The Camouflet factory had to create a specialized custom piece of equipment for the screen placement requirements. The first heater plate in the cap housing is now set at 1mm distance off of the intake holes. After much testing, the Camouflet team found that this small space is pivotal in the optimal Camo cap performance. It makes the cap more forgiving to heating. The heater plates are now laser welded into place with 3x small "dot" markings on the outside of the cap. This will remove the possibility for plates to get dislodged and keep the cap from getting "stuck" on the chamber.
• Stem - 8mm precision bore throughout. Add the chamber or mouthpiece of your preference to either end of the stem. Better fit and ease of assembly for the ceramic tubes and o-rings. Mouthpiece taper has been improved for better fit into 10mm glass joints.
• Chamber - The ceramic tube can now be inserted into the back/male connection side of the chamber allowing for a single o-ring for assembly, seen below. The chamber connection has also been extended for a more secure connection to the stem. Assembly tip: make sure to align and center the chamber and stem connection points when inserting the chamber into the stem to avoid damaging the chamber o-rings.