This listing is for 1 x Qaroma Quartz Housing or a Top/ Bottom replacement part only. We recommend purchasing full kits, unless you are well versed in sourcing/ setting up your own Controller and Coil. We are not responsible for any issues arising from mix/match of parts.
Note: Qaroma is only warranted for Dead on Arrival (DOA) cases, reported within 24 hours of receipt, with proper evidence. Please take care of your Quartz products.
Note: When resting the heater for a long time, the Qaroma Stand will feel like touching a bowl of hot soup. However, it is safe to touch for a few seconds.
Stretching a coil:
The coil does not need to be stretched to use with the Qaroma housing, however some people still like to separate their coils slightly for better heating.
Use a small flat head screwdriver or similar tool and be careful not to slip and stab yourself in the fingers. Insert the tool in between the first coil and slowly lever it back and forth, making small adjustments. Keep sliding the tool along the coil, stretching as you go, all the way to the bottom of the coil until its stretched to the desired size. The coil needs to be stretched slightly longer than the Gemstone Chamber length, and then pushed back (like a spring) with the cap, for a good and tight fit- again not recommended for the Quartz housings.
Burning off a coil:
All QaromaShop kits and coils supplied through A Friend Indeed Australia come already primed for use and a coil burn off has already been perfomed in house. If you do need to perfom a burn off for any reason, the instructions can be found below.
Place the coil in the porcelain stand, plug it in to the PID, turn it on and set to 900°F. Wait for 15-20 minutes to let the coil heat up and burn off any residual oils or contaminants from the manufacturing process. After the burn off is complete, turn off the PID and let you coil cool down completely before handling.
Fitting the wooden handle:
All QaroamShop kits supplied by A Friend Indeed Australia come with the wooden handles already fitted, however if you need to fit a replacement, follow the instructions below.
Flatten out the 5 wires inside the heater cable by rolling them under your thumb and forefinger. When you can feel they're all side by side, while still holding the cables in place, push the cable into the groove of the handle and slide the handle along the cable until the cable runs through the entire length of handle. Its easiest to start at least the length of the handle away from the coil end of the cable to give enough space to slide the handle along whilst fitting. The handle should be slid along the cable until it sits over the silver connector that connects the cable to the metal coil.
1 x Qaroma Housing or a Top/ Bottom replacement part only.
Designed to be used with a 30mm QaromaShop coil. Due to the tight fit between the housing and the coil, we can not guarantee other manufacturers coil will fit the housing.
Fits up to 165 3mm ruby pearls.
Best run between 650f and 750f
Not recommended for use as a double decker/with concentrates.
JOIN THE HIGH END SOCIETY
If you're a big-time enthusiast of high-end glass, you'll love our exclusive 'High End Society'! We offer members of the 'High End Society' access to our limited access mailing list. This list offers special quarterly discounts on online items from our store, as well as early access to our latest and greatest high-end glass. If you've always wanted to be ahead of the curve when it comes to our brand new glass drops, you're in for a treat!