Taroma 2.0 Ball Vape by QaromaShop

Before assembling your Taroma 2.0 it is essential to perform a coil burn-off. First you should fit your wooden handle onto the coil cable. Flatten out the 5 wires inside the heater cable by rolling them under your thumb and forefinger. When you can feel they're all side by side, while still holding the cables in place, push the cable into the groove of the handle and slide the handle along the cable until the cable runs through the entire length. Its easiest to start at least the length of the handle away from the coil end of the cable to give enough space to slide the handle along whilst fitting. The handle should be slid along the cable until it sits over the silver connector that connects the cable to the metal coil. Once assembled, simply place the coil in the porcelain stand (supplied in the kit) and set your PID to 900°F. Wait for 15-20 minutes to let the coil heat up and burn off any residual oils or contaminants from the manufacturing process. How to stretch a coil- With a flat head screwdriver or the likes. Go slow and make small adjustments until its stretched to the desired size. The coil needs to be stretched slightly longer than the Gemstone Chamber length, and then pushed back (like a spring) with the cap, for a good and tight fit. With the burn off completed, allow the coil to cool for 15-20 minutes. With that all taken care of, you can now fully assemble your housing. Just place the coil inside the housing, fill the housing with the Ruby Pearls and screw on the top of the housing, being careful not to overtighten or overfill with pearls. Place the housing back into stand, turn your PID back on and be sure to reset temperature- QaromaShop recommend starting at 510°F and increase as required. Whilst waiting for your device to reach the desired temperature, using the stainless-steel scoop, loosely pile your herb into the bowl. Once the Taroma 2.0 is at temperature, simply place the housing on top of your bowl and begin inhaling. NB. Some people like to "heat soak" their bowl before the first hit. To do this, place the pre-heated housing on top of your bowl and wait 15-30 seconds before inhaling. The Taroma 2.0 fits around 165 3mm pearls, 95% of which sit directly in the heater coil zone. The additional air holes have been chamfered to increase airflow and accommodate concentrate use; the top 5% of the gem stone chamber does not sit in the coil zone and therefor ensures any concentrate added has to melt through to the coil zone and not completely vaporize off immediately. A few threads on the cap can be sacrificed, to increase Gemstone Chamber capacity further. This is not necessary for most users. Cleaning your Taroma 2.0 is pretty straightforward. For optimal airflow, we recommend swapping screens every few bowls. Users can brush out their bowl and screen after each use, which will help airflow stay open for longer. Bowls and screens can be soaked in isopropyl alcohol and rinsed for easy cleaning. It is important to note that after resting the heater in the porcelain stand for a short period, it will feel like touching a bowl of hot soup- safe to touch for a few seconds but hot none-the-less. Under no circumstances should you leave your Taroma 2.0, or any QaromaShop products, unattended while in use or turned on. A Friend Indeed Australia cannot and does not assume any responsibility or liability for the improper use of products, or any hazards or injuries caused by operator negligence.

Coil (Male 5 pin XLR connector) PIN 1 = TC-, PIN 2 = TC+, PIN 3 = GND, PIN 4 = AC-, PIN 5 = AC+